Amazon BFB-3000 Especificaciones descargar pdf (Pagina 38)

BFB-3000 Set Up and Operations Manual

Document No: D100253 38

Recommended maximum extrusion temperatures for materials:

Material

Extrusion temperature (°C)

ABS

260

PLA

195

Note: Extruders share power, therefore an extruder will heat up quicker if it is the only

extruder with a high target temperature.

6.9.3 Purge the extruder

 Ensure filaments are loaded into the extruders, as defined in the section “Load the

filament”, page 31.

 Make sure the springs on the extruder pressure bearings are fully compressed.

Compression needs to be adjusted from this setting.

 Proceed by purging one extruder at a time:

 Heat the extruder to the maximum temperature defined below, depending on the

material in the extruder:

Material

Extrusion temperature (°C)

ABS

260

PLA

195

 Once target temperature has been achieved, turn the RPM up to 15.

 If the motor on the extruder stalls (you will hear a ‘clicking’ sound) release the

pressure on the filament by unscrewing the pressure bearing bolt with the hex driver

until extruder motor stops stalling (motor will run without clicking). After this point,

unscrew the bolt another half turn to ensure the motor does not stall during

operation.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 72 73

Sin comentarios

Amazon BFB-3000 Especificaciones Pagina 38